SXG Series Whirly Flashing Drier

■ Inregrity of grinding, drying and grading;
■ Making up pasty filter cake directly intgo dry powder;
■ Close combination of professional theory and rich practice;
■ Completing design, manufacture and commission-handing over key project.

Working principle
■ The hot air enters into the bottom of the drier in tangent direction. Under the driving of the stirrer, a powerful rotating wind field is formed. The paste state materials enter into the drier through the screw charger. Under the powerful function of the stirring vanes at high-speed rotation, the materials are distributed under the function of strike, fric- tion and shearing force. The block state materials will soon be smashed and contact the hot air fully and the materials are heated and dried. The dried materials after the de- watering will go up with the heat-air flow. The step rings willl stop and keep the big particles. Small particles will be discharged out of the drier from the ring center and will be restored by the whirl separator and dust remover. The not-fully-dried or big piece materials will be sent to the wall of the equipment by centrifugal force function and be smashed again after they fall dowm to the bottom.

Schmatic of structure
1.blower
2.heater
3.air distributor
4.stirrer
5.screw particle addingdevice
6.drier
7.sorter
8.whiri separator
9.star shaped dust remover
10.cloth bag dust remover
11.induced draft fan

Main technical parameters

Note:the evaporation quantity listed in the above table is suitable for the evaporation quantity at the time of the air inlet temperature and of the air outlet temperature .for the special meaterials,the above parameters will be changed.